Are your bot's commands not appearing? Here are a few fixes:

• Make sure the command is published to the correct branch. Use the publish button at the top of the block list in the flow editor.
• Go to Settings > Application Commands and ensure the command is showing up there. If it is, just click "Sync to Discord". If not, the command may not be published on the correct branch.
• If the command shows up correctly in the Application Commands menu but not in Discord, it may take up to 15 minutes to fully sync with Discord.
• Ensure the bot is in the server
  • Make sure the bot is in the server and is able to create commands.
  • If you used an invite link other than the one Inventor supplies from the sidebar, check that Installation > Default Install Settings has both application.commands and bot enabled, then invite the bot again.
• Ensure you have permissions to see commands
  • Make sure the Integrations tab isn't estricting your ability to see commands.
• Ensure the command isn't "Age Restricted"
  • Make sure you didn't accidentally restrict the command to NSFW-designated Discord channels only. You can find the setting in the Trigger page of the flow.
• Check for sync errors
  • Go to the errors page and check for any errors with syncing your commands.

If you're still having trouble, please share all relevant screenshots of the above steps and anything else you've tried in the appropriate support channels.